ALIBARBAR VAPE News
Alibarbar Fl Code Reset
Jun
It looks like you’re asking about resetting the “FL code” on an Alibarbar device — most likely the ALIBARBAR INGOT series, which can sometimes show a small “FL” code on its display or near the airflow.
Here’s what you need to know:
What Does “FL” Mean on an ALIBARBAR Device?
On ALIBARBAR rechargeable models (like the INGOT 15000, INGOT 9000, or Ice Adjust 12000), the display might show a short code when:
The device is freshly unboxed
The airflow sensor needs a quick reset
You’re toggling through certain hidden functions (rare on most disposables)
“FL” likely stands for “Flow” or “Flavour” mode, and in some cases it can be reset by a simple 3‑step process.
How to Reset the FL Code (or clear it)
Try this sequence:
Turn the device off – If it has a power/airflow switch, set it to OFF. For draw‑activated models, just stop using it for 20 seconds.
Disconnect the charger (if plugged in) and ensure the USB port is clean and dry.
Perform a manual reset:
Hold the draw sensor (the small hole near the bottom/top) and tap the bottom of the device gently against your palm 2–3 times.
Some users report that taking 3 quick, very short puffs in a row (without inhaling fully) triggers a sensor recalibration, clearing the FL code.
Re‑test – Try a normal puff after waiting 10 seconds. The FL code should disappear and the device will function normally.
If the FL Code Persists
Check the e-liquid level – If the device is near empty, the “FL” might indicate a dry coil warning. Time to replace it.
Faulty airflow sensor – In rare cases, a stuck sensor can repeatedly show FL. Try blowing gently into the mouthpiece once, wait 5 seconds, then inhale normally.
Contact support – If none of the above helps, your device may need replacement. Reach out to ALIBARBAR VAPE Australia Store and they can assist with warranty or advice.
Quick note: ALIBARBAR devices are designed for plug‑and‑play use, so there’s usually no complicated code‑resetting procedure needed. The above steps cover 95% of “FL code” situations reported by Australian vapers.
If you’re still stuck, feel free to provide the specific model (e.g., INGOT 15000) and I can give you more precise troubleshooting.