How To Open Alibarbar Ingot

Here’s how to get your Alibarbar Ingot ready to use:

Unboxing & First Use

Remove the outer packaging – Slide the device out of the box and take off any protective film or plastic wrapper.
Take off the silicone caps – There are usually two: one on the mouthpiece and one on the bottom (over the airflow sensor). Pull them both off and discard.
Check the airflow – Some Ingot models have an adjustable airflow switch at the bottom. If yours does, set it to the middle position to start.
Activate by drawing – Alibarbar Ingot devices are draw‑activated (no buttons). Simply place the mouthpiece to your lips and inhale gently. The LED indicator will light up, and vapour will be produced.
First few puffs – The very first draw might be slightly lighter in flavour; this is normal as the coil primes. It should reach full taste within 4–5 puffs.

Important Notes

Do not attempt to pry open the device body – the Ingot is a closed‑system disposable, and opening it can damage the battery, cause leaking, or void any warranty.
If the device doesn’t activate, check that both silicone caps are completely removed and try inhaling a little more firmly. Still not working? Contact the retailer for a replacement.
Store the device upright and away from extreme heat (e.g., don’t leave it in a hot car).

If you have any trouble with your Ingot or want more details, the team at ALIBARBAR VAPE Australia Store can advise you directly – visit https://alibarbar-vape.net for support.